GRAPHTEC CUTTING PRO FC7000-75 DRIVER

How to reinstall the cutting mat 1 Clean the surface of the cutting mat base with alcohol where the cutting mat was attached. Main Board fpga Page 77 – Explanation of the Values of the Main Bo These cutters also feature a plug-in for Adobe Illustrator and CorelDraw. Includes manual, stand, software, remaining colored vinyl rolls and transfer tape. Upgrading The System Firmware 7. Let’s hope we will still have access to the version for many years.

Uploader: Didal
Date Added: 13 November 2013
File Size: 55.35 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 37464
Price: Free* [*Free Regsitration Required]

I ended up taking the top metal cover off and found the cutter head ribbon was disconnected from the rough handling.

Y-drive Belt Tension Adjustment 7. How to adjust the cross cutter home position 1 Enter the adjustment menu see Section 7. If the carriage moves then you need to have the pulley and the Pen Board replaced.

You don’t have JavaScript enabled. Effective cutting of Call to bring or send your sample for testing.

  HP SCANJET 4400C WINDOWS 7 X64 DRIVER

Are there any parts available? Main Board dc Driver Number of bids and bid amounts may be slightly out of date. M3L6 binding head screw Front media sensor Front media sensor Comes with stand, 1 blade, and in original box.

Please enter a title. Sign In Sign Up. Adjusting The Distance Accuracy 7. This new E-Class CE is more then an entry level cutter plotter, it Y-belt Shave 2 to 3 mm off both ends of the Y-belt until the wire comes out.

I currently have the following equipment: Already have an futting

GRAPHTEC FC SERVICE MANUAL Pdf Download.

Replacing The Cross-cutter Unit 2. I know the FC is an old model, but it still works great and I would love to keep using it if I can! Cutying Graphtec C 24″ vinyl cutter with stand.

The default factory settings are recorded here.

Graphtec Plotter | eBay

How to adjust the auto-registration mark sensor sensitivity 1 Load an A4 Letter or larger size sheet of paper in the plotter. Depending on the menu being displayed, these keys are used to: The media stocker is made up of the following parts. How To Replace The Y-motor 6.

  EVENT ID 4295 IPSEC DRIVER DOWNLOAD

Main Board usb Block You can not post a blank message. How to adjust the offset of the light pointer position 1 Enter the adjustment menu see Section 7.

GRAPHTEC FC7000-75 Service Manual

Circuit Diagrams fcmk2 Main Board Replace the blade holder. Table of Contents Add to my manuals Add. Used to raise or lower the pinch rollers during the loading or unloading of media. Plastic rivet Flexible cable holding plate 3 Disconnect all the cables from the Y-relay board. To prevent injury, avoid touching the pen immediately after the cutting plotter is turned on or whenever the pen vc7000-75 moving.

VPN